Zinc-manufacture,factory,supplier from China

(Total 24 Products for Zinc)
Zinc Borate is an environmentally friendly non -halogen flame retardant. It has the characteristics of non -toxic, low -water solubility, high heat stability, small particle size, small gravity, and good decentralization. As a high -efficiency flame retardant Rubber, coatings and other fields.
  Contact Now
Molecular weight: 65.39 Grade: 5N MDL number: MFCD00011291 EC number: 231-175-3
  Contact Now
Potassium hydroxide is a common inorganic base with a chemical formula of KOH and a molecular weight of 56.1. It is a white powder or flake solid at room temperature.
  Contact Now
Hydrogen Peroxide Solution is an aqueous solution of hydrogen peroxide.
  Contact Now
Oxygen is a simple substance composed of oxygen. The chemical formula O2 has more vivid chemical properties, and most of the elements can react with oxygen.
  Contact Now
Chemical reagents are relatively standard substances for chemical research, ingredient analysis, is an important condition for scientific and technological progress, which is widely used in the composition of material, other, qualitative and quantitative analysis.
  Contact Now
Biphenyl is found in coal tar, crude oil and natural gas. The preparation methods of biphenyl include the chemical composition method of making biphenyl through benzene pyrolysis and the separate extraction method of making biphenyl through various coal tar fractions. The mass fraction of biphenyl in coal tar is 0.20%-0.40%, and coal tar extraction method and chemical composition method coexist.
  Contact Now
Light yellow to white granular crystals (semi-circular) white to light yellow loose crystals, heating is made black.
  Contact Now
Miscible with ether, diethylene glycol, acetone, carbon tetrachloride, benzene, chlorobenzene, kerosene and olive oil. It can react with hydroxyl-containing compounds, water, amines and compounds with active hydrogen atoms to generate carbamate, urea, semicarbazide, etc. Toluene is nitrated with mixed acid to obtain 2,4- and 2,6-dinitrotoluene, and then hydrogenated and reduced in the presence of nickel catalyst to obtain 2,4- and 2,6-diaminotoluene, which is then reacted with light in chlorobenzene solution. produced by gas reaction.
  Contact Now
Product Quality: Chemical Abstracts Number: 101-14-4 Appearance: Light yellow to white granular crystals (semi-circular) white to light yellow loose crystals, heating is made black. Microfincture. Content: ≥ 85% Melting point: 98-102 ° C Dry loss: ≤0.2%
  Contact Now
Only a small part of ammonia molecules react with water to form ammonia monohydrate, which is a weak base that only exists in ammonia.
  Contact Now
Solubility: Insoluble in water, acid and alkali, but soluble in organic solvents such as alcohol, ether and benzene.The preparation methods of biphenyl include the chemical composition method of making biphenyl through benzene pyrolysis and the separate extraction method of making biphenyl through various coal tar fractions. The mass fraction of biphenyl in coal tar is 0.20%-0.40%, and coal tar extraction method and chemical composition method coexist.
  Contact Now
Glass material is referred to as a glass instrument. Many glass instruments are used in the laboratory, which is highly chemically stable, thermal stability, and well-transparent, and good insulation function.
  Contact Now
Aspirational antioxidants should have the following conditions: ①Should have high anti-oxidation ability; ②Good compatibility with resin, no precipitation; ③Good processing function, non-volatile and non-decomposing at the processing temperature of high polymer; ④Good resistance to extraction, insoluble in water and oil; ⑤The color of itself is best to be colorless or light-colored, so as not to pollute the product; ⑥Non-toxic or low-toxic; ⑦Low price. In fact, any kind of antioxidant can not fully meet these conditions.
  Contact Now
Industrial ammonia is an aqueous solution containing 25% to 28% ammonia. Only a small part of ammonia molecules react with water to form ammonia monohydrate, which is a weak base that only exists in ammonia.
  Contact Now
Potassium hydroxide is strongly alkaline and corrosive, and its properties are similar to sodium hydroxide, which can cause burns. It can absorb water and dissolve in the air, and absorb carbon dioxide to gradually become potassium carbonate. The pH of the 0.1 mol/L solution is 13.5.
  Contact Now
HCFC-141b (monofluorodichloroethane) is a high-purity liquid widely used in cleaning and solvent fields. Because its damage to the ozone layer is 1/10 of CFC-113, it is designated as an ideal substitute for fully halogenated chlorofluorocarbons. HCFC-141b is a widely used non-perhalogenated chlorofluorocarbon. Although its destructive effect on the ozone layer has been greatly reduced compared to fully halogenated chlorofluorocarbons, it can still cause damage to the ozone layer that is difficult to recover. As a result, its use is gradually being reduced around the world.
  Contact Now
When the temperature drops to 2.18K, the properties of liquid helium will change suddenly, the viscosity is very small, and it becomes a super fluid that can flow upwards along the wall of the container. The thermal conductivity is 800 times that of copper. It becomes a thermal conductor with excellent thermal conductivity. Its specific heat capacity, surface tension, and compressibility are all abnormal. This abnormal liquid is called liquid helium II, and the normal liquid helium is called liquid helium I.
  Contact Now

Relate News

The principle of potassium hydroxide removal of oil stains is actually a simple chemical principle. Since oil stains are a lipid chemical substance, from the analysis of its chemical composition, they are higher fatty acids and glycerides.
Sulfonated cobalt phthalocyanine is an effective catalyst for removing mercaptan in light oil. Gasoline containing sour crude oil has a relatively high sulfur content.
There were many chemical material varieties, mainly is the material in chemical industry, used to produce chemical products, chemical material can be divided into two types: organic chemical material and inorganic chemical material
Glycerol (also known as glycerol) is an organic substance that is colorless, odorless, sweet in taste, and has a clear, viscous appearance. It is miscible with any proportion of water, alcohol, amine and phenol, and the aqueous solution is neutral. Glycerin is a polyhydric alcohol humectant, and the hydroxyl groups form hydrogen bonds with water molecules in the molecular structure, which plays a good role in absorbing water and locking water. Glycerin has a wide range of uses, with more than 1,700 uses currently in use in food and industry.
The shape of sodium persulfate is milky white crystalline powder, which is soluble in water, and can accelerate the dissolution in wet humidity and high temperature; it can be dissolved by ethanol and silver ions, and the solubility in water at 20℃ is 549g/L; sodium persulfate is also deliquescent , In humid air and high temperature can accelerate the dissolution of sodium persulfate, release oxygen and become sodium pyrosulfate.
Antioxidants can be used as hydrogen donors to scavenge free radicals generated during the chain initiation stage, thereby inhibiting or reducing the oxidation of oils. Therefore, in order to delay the oxidation of fats and extend their shelf life, the most common and effective way is to add antioxidants to the fats.
Castor oil is a kind of fatty acid triglyceride, which exists in castor bean seeds, and the content is between 35% and 57.%.
TDI is the abbreviation of toluene diisocyanate. TDI is a polycyanate widely used in industrial production. It is a polyurethane material and an important basic material. Mainly used to make flexible polyurethane foam, polyurethane elastomer, coatings, adhesives, etc.
Titanium dioxide itself has strong photochemical activity, and is prone to inactivation, yellowing, powdering, etc. under the sun, especially ultraviolet rays. A layer of inorganic material is wrapped on the surface of the titanium dioxide, which not only gets rid of the above defects, but also improves the characteristics of the titanium dioxide product.